Jump to content

3blake7

Dormant
  • Posts

    2
  • Joined

  • Last visited

3blake7's Achievements

0

Reputation

  1. this is with the settings in the screen shot and 0.35mm line width
  2. if i want to try out your experimental builds with your bridge settings, where would i get the source? i use ubuntu, i can compile it if need be. also, ive been playing around with the bridge settings. i have attached a picture. the top one is with 0.3 line width, the bottom one is with 0.5 (cura default?) (before i updated retracting and tried 0.35 line width) . i have a 0.4 nozzle (creality cr-10 mini). the 0.35 settings look good for the rest of the print but the skin lines dont connect on a bridge at 0.35 but they do with 0.3 . i have done an extruder test twice and updated my estep. id prefer to keep the 0.35 line width since it reduces print time and the rest of the print looks good. i have tried increasing bridge skin flow to 100% then 150% but it doesnt seem to make a difference? bridge skin density is set to 100% but i was thinking it may help if i could go 120% instead, but cura doesnt let me raise it that high. i have attached picture of current bridge settings. also attached picture of a bad slice. cura tries to do the outer ring of the hole first, when it's not touching anything, instead of working its way out. not sure how to solve that. i tried outer first, infill first, etc but didnt appear to change its order of operations. ended up using supports. thanks!
×
×
  • Create New...