Jump to content

Adri-an

Dormant
  • Posts

    3
  • Joined

  • Last visited

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

Adri-an's Achievements

1

Reputation

  1. Es entsteht kein (bzw. ein vernachlässigbar kleiner) Fehler durch Temperaturdehnungen, sondern durch erkaltendes Filament am 2. Core, das während des Levelns nicht mehr plattgedrückt werden kann. Dieser ist so groß wie die Größe des Filamenttropfens. Heißt: Core 1 ist perfekt aufs Bed abgestimmt, Material aus core 2 wird in die Luft gedruckt. Ich muss den Druck abbrechen und das Prozedere so oft wiederholen, bis einmal zufällig kein Tropfen am core 2 hängt. (zu Finden in den Threads https://community.ultimaker.com/topic/29722-breakaway-ooze-wrecks-auto-level und https://community.ultimaker.com/topic/29553-can-get-the-support-to-print-correctly-sometimes/) Während des Drucks macht es aus meiner Sicht Sinn, dass das gerade nicht verwendete Filament auf einer kühlen Idle-Temperatur gehalten wird, damit es nicht aus dem Core "sifft" ;), aber nur während des levelns sollten beide cores heiß sein! Wir drucken eigentlich ausschließlich mit Tough PLA und Breakaway, den S5 kann ich durch dieses Problem faktisch nicht mit beiden cores nutzen. Ich bin darüber super frustriert und nutze den S5 zur Zeit nur für extrem große Bauteile. Hat jemand / S5 Nutzer das das gleiche Problem oder eine Idee wie ich das Lösen kann?
  2. Hi @Sk7500, we have the same leveling issues with our S5 described [here] I'll keep that in mind and give it a try. It's not solving the main problem, but maybe it's a suitable workaround, thanks for the hint.
  3. I can confirm the issue @jones007 mentioned, I have EXACTLY the same problems with our UM S5 right now, driving me cazy. From my point of view the bed leveling process on the S5 does the following: 1. heat bed 2. heat core1 and core2 3. z-level core1at one point, switch to core2 and z-level core2 at the same point 4. switch to core1 and "scan" the whole bed. During that (time consuming) process, core2 cools down. 5. switch to back (to cooled down) core2 and measure 3 points of the bed. 6. start print. The issue: at 5.) the bed is beeing measured by a material blob on core2 that can't be pressed flat (like at 2.)) and you can cancel the print --> error distance between core1 & 2 sizing that materialblob. So now my question: How can let UM S5 keep core 2 heated during the whole leveling or better: heat it once again before measuring the 3 point of the bed?! Thanks in advance for quick reply, I practically can't use the S5 right now at all.
×
×
  • Create New...