Jump to content

Deagle0412

Member
  • Content Count

    4
  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. I turned off active leveling and ran a print. The issues was resolved. Tried to do some cold pulls and other possible causes and everything turned out fine. So it must be a issuse with the active leveling. Thanks for the recommendation. I have been using blue tape for a long time and figured out tricks for it. Easy adhesion and also ease release.
  2. I turned off active leveling and ran a print. The issues was resolved. Tried to do some cold pulls and other possible causes and everything turned out fine. So it must be a issuse with the active leveling. Thanks for the recommendation.
  3. I have performed multiple manual levels. I think possibly an issue with the active leveling?
  4. Printed for 3 days and didn't have an issue. Tried reprinting one of the same prints and now it keeps failing. Any idea as of why this may be happening? (See picture). No setting were changed. As you can see that the left points fine but as it goes right it gets thinner and fails.
×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!