Jump to content
Ultimaker Community of 3D Printing Experts

c_popa

Member
  • Content Count

    3
  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. Tkank you all ! Now I have enough solutions (ideas) to try. Also, I have the proof that imagination and engineering can solve any problem ... All the best and enjoy printing !
  2. Thank you, I will follow your suggestion. I was thinking also to a solvent wich can dissolve the material locally (the two ends), but I found no such chemical stuff. Best regards, and happy printing !
  3. Hello, I have a lot of CPE+ wire 2.85mm "leftovers", too small to be used for printing an entire part, but also too long to be scrapped. Is a solution to join them in a single wire ? I tried to weld two ends (using a lighter), but the rate of success is about 5%...
×
×
  • Create New...