Jump to content
Ultimaker Community of 3D Printing Experts

MicroRotors

New member
  • Content Count

    1
  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. Hello All, I have a problem with a print that failed about halfway through during a 10-hour build. It was printing air when I woke up. After cleaning up the part, I see it failed at Layer #135. My problem is I am unsure about how to start another print so it can glue it to my existing half. I have already removed the part from the machine. My Machine is an IIIP-I3/Plus. (Monoprice Maker Select Plus 3D Printer) The Software is, IIIP-Cura. (I'm not sure which build it is as there is no tab to check. It came with the machine in 2017 when purchased) Print Mate
×
×
  • Create New...