Jump to content

Lummy

Dormant
  • Posts

    3
  • Joined

  • Last visited

Lummy's Achievements

0

Reputation

  1. I have not noticed that problem. I have seen a few things online in regards to moving the filament spool down a bit, I would look at that first (before I start messing with feed rates)
  2. I ended up re-formatting a fresh Micro SD, that finally fixed my issues. I could read and write to the card just fine, so I never suspected it, on a whim I re-formatted and everything started working.
  3. I have tried everything I can possibly think of and I can not for the life of me get this thing to print anything other then the preloaded files. I have tried 3 different versions of cura (including the one that came preloaded). I have copied and pasted gcode from everything I can find. Any model I load to the printer goes from 0% to finished in a matter of seconds, the printer makes a tiny movement (it is small and I cannot tell the direction) then is says print finished. Any help would be greatly appreciated. I am currently on Cura 4.4, windows 7 64 bit, with the Anet ET4 printer.
×
×
  • Create New...