Jump to content

rioz

Dormant
  • Posts

    6
  • Joined

  • Last visited

rioz's Achievements

0

Reputation

  1. I run Cura 4.4.1 in CentOS7 and error and warning messages shown. May I know whether gcode file exported can be used for 3d printing without problem? Fontconfig error: "/etc/fonts/conf.d/10-scale-bitmap-fonts.conf", line 71: non-double matrix element Fontconfig error: "/etc/fonts/conf.d/10-scale-bitmap-fonts.conf", line 71: non-double matrix element Fontconfig warning: "/etc/fonts/conf.d/10-scale-bitmap-fonts.conf", line 79: saw unknown, expected number Fontconfig warning: "/etc/fonts/conf.d/65-0-lohit-bengali.conf", line 32: unknown element "langset" Fontconfig warning: "/etc/fonts/conf.d/69-gnu-free-sans.conf", line 24: unknown element "langset" Fontconfig warning: "/etc/fonts/conf.d/69-gnu-free-serif.conf", line 24: unknown element "langset" qml: TableViewSelection: index out of range qml: TableViewSelection: index out of range
  2. Will it caused by step motor overheat? I found the step motor (x axis) is very hot after printing an hour.
  3. I got layer shifting in the printouts. Model is rendered in Cura and looked ok. But most of them will shift in X axis (shown in figures). Anyone has experience on it and can share your solution? Is a hardware or software problem? Any method to check if there is a layer shifting (in Cura or gcode) and prevent it?
  4. Thanks sir. I fixed it by setting the filament diameter in cura.
  5. Yes, I am using 1.75mm filament. How can I fix it if your guess is correct.
  6. I use default setting in cura 4.4.1 and get brittle printout. I tried to increase printing temperature between 210 to 230 but still get the same result. Any one can give me some advice to solve it.
×
×
  • Create New...