andrei2306

I upload another photo. Looks like is makung some small dots not everywere just in the curves. On straight lines is ok the printing

Hello i have a anycubic mega s printer and when i print you can see in that photo on cornerners look like the surface have some printing issues. Can i change some setting is cura?

i have a anycubic i3 mega s and i try to print tpu and is impossible take a look in the photo . Is starting to print and after few second i makes like you see in the photo and also it stopes to take out fillament

I am a beginner i don't understand too much what should i change to retract ?

Hello I have a problem when i print tpu in the middle you see when is moving to the other part is leaving a thin material and connect the parts. What i can do?

No i didn't try yet but i will

I still have this problem when is moving to another zone is moving very fast and is passing thru the middle and leaving a line of the material you can see in the photo do you have any idea how to correct this problem??

you mean this?

I don t understand what means "try to tweak your retraction and z-hop settings"

Hello When is moving the printer to go to another zone for printing is leaving material on the back and destroy my project what i need to do? I print with PLA at 200 °C stadard cura settings

I have a anycubic i3 mega s. i change to 0.25 nozzle and looks like is working

now is working is showing good

Same result

Hello I try to print something but is not right , when i look in Cura app it shows like it couldn't print all. Anybody know why? I attache 2 photos to see how it needs to be and how it looks on the simulation. I need to make some changes?

Hello I have a problem i don t know what to do to print a fillet. I design this product but the fillet is imposible to print what i can do? My result is a mess is not ok the fillet

thank you for the answer you help me

Hello I am new in the 3d world , I want to print 4 models but not in the same time (constant Z), I want to load the g code and to print 1 by 1 when the printer finish 1 to go to the other model is it possible? I attache the photo is just an example. I want to do this because when i try to print them in the middle and all in the same time afhter the 3 layer 1 piece get off from the platform and destroy the other models.