Dkobes

It almost seems like it’s trying to iron the piece for a few layers, I have an indicator knob on the stepper and it’s not turning as it’s going through the motion. Could be a loose wire as well I’ll have to do more troubleshooting but it doesn’t seem to be grinding the filament flows freely when I cancel the print and start a new one

Yeah everything else moves as normal but the extruder stops feeding filament. I’m running a CR-10 V2. I just installed Cura 4.5 so I’m wondering if something didn’t go wrong with the install. I never had this problem before

I’m having the exact same issue, halfway up the print and it just stops extruding. It looks like it’s just trying to iron the print rather than trying to add filament. Like the extruder motor doesn’t try to spin at all I can’t figure it out to save my life