Jump to content

chicortiz

Dormant
  • Posts

    7
  • Joined

  • Last visited

chicortiz's Achievements

1

Reputation

  1. Thank you but in Cura's preferences I have only "Configure Cura". What should I do?
  2. Hello everyone! I'm working with a Ultimaker 3D printer that does not have a heating bed. Do you know where I change the setup inside Cura software so that this situation is addressed? Thank you very much for your time!
  3. Hello Folks! I'm trying to use an Ultimaker that is available at a public hub. I don't know which model is it, there is no indication at the carcass. But there is a serial number. Do you know if it is possible to know which model is this 3D printer by it's serial number? Thank you very much for your time. Greetings, Ortiz
×
×
  • Create New...