mmsg

Hello! I also discover the same issue on my Ultimaker S5 (early 2019) - Firmware 6.3.0 and Cura 4.8. It happens quite frequently, maybe 3 out of 10 prints. I feel it happens especially on larger print files - print job 10+h and I do not use "One at the time" print (since it was discussed above). @robinmdh you stated that error reporting to that particular warning is available. How can I access this log file and can I actually read it or do I need Ultimaker Support on that?

Hello Community, I have an issue when I want to speed up my outer wall. It seems as soon I get above the value of 39mm/s for the wall speed (calculated: outer wall: 26mm/s inner wall: 39mm/s) the top and bottom wall speed is faster then the speed inbetween. I attached a screenshot showing this issue. Did anybody discover similar - and is there any value I miss to adjust the outer wall speed to be uniformal from bottom to top for this higher speeds? For reference: Cura 4.6.1; Settings for UM-S3 with PLA, 0,4mm Nozzle - Speed, Acccel, Jerk Speeds visible in Screenshot