Roverius

I have setup Cura v4.5 after long time using V15.04 With my previous version, i never had any issues. I have setup a custom printer and when i want to print the printer waits for a "Click to Resume" command on the display. This happens after G29 autolevel. It also happens sometimes after heating up. I have tried with a preconfigured printer that comes near to my custom printer, a anycubic i3, but it has the same issue. Is there a setting that can avoid the "Click to Resume"? I do also have a Anet A6, that is listed under the custom printers, but havn't tested it to see if it has the same issue. Thanks in advance -Roverius

OK, I misread, the Origin at center should NOT be ticked on. Lets try again :)

Hello I do have the same issue, i made just a test cube and placed it on the center of the bed. I have a custum setup printer (FLSun i3 large) and ticked "Center" on. Still, it starts to print on the corner. Cura V4.5 With Cura 15.04 there was no issue.