Jump to content
Ultimaker Community of 3D Printing Experts


New member
  • Content Count

  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. Can anyone give me some pointers on this as I'm a noob and trying to play catch-up. About 50% of the jobs I print fail as the print will sometimes start OK, and then 'offset' by anything from 1-2mm up to 15mm - I've attached an image of an example this morning. Clearly, being offset from the brim is a bit of a pain but not disastrous but when it happens towards the end of a job, it makes me want to throw the whole thing out of the window... I've had issues where belts weren't tight enough and seeing the effect of the belt 'missing a tooth' on the cog, but I
  • Create New...