dhall419

Ender 3

I have been using Cura for about 1.5 years and version 3.6 works great. I got tired having to close the little message about the newest version, so I installed 4.5. All the prints with 4.5 come out spongy, soft on the sides. So I made a .5 x .5 block, printed with 3.6, took 13 minutes, sliced it in 4.5 and it only took 10 minutes, this was after I had compared all the settings, that I have coming up. I know there are many more settings, that I don't use or see. The speed, infill and wall count is set the same, what other settings could be at fault? Is there a way to do a data dump of all the settings, where I could compare all the settings? It has to be one that I don't have turned on.