saroneh

Thank you very much!

Hi Robert Thank you for the reply! Would it really be necessary to replace the entire board? I was hoping for a fix that didn't cost above $100. Why not just replacing the connectors on the board or using the temp2 outlets? Of course, the later will require recoding the software.

Hi My Ultimaker 2 build plate suddenly stopped heating. I heavily suspect the issue tot be related to the wiring to the main boards. The wires are almost all melted and the same with the connectors to the board. I recently printed approx 4x1hours with a temperature of 70degree celcius. I don't suspect this should be an issue when the software allows me to set the temperature this high. Have anyone else experience the same and shouldn't this be prevented by some safety feature? I see a clear risk of the printer self igniting. I bought the printer for 4 year ago, so I don't think that the warranty is applicable anymore. Can anyone guide me to where I could order the green connectors?