Jump to content

Jhankinson

Dormant
  • Posts

    1
  • Joined

  • Last visited

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

Jhankinson's Achievements

0

Reputation

  1. Just wondering if anyone else has had this problem. I have an UM3 and just started trying to print with 2 filaments - PLA/PVA. My printer always extrudes the second filament (PVA) from a distance above the bed as it seems to miss the lift notch when it switches to the second extruder. I'm using Cura 4.5/most recent UM3 firmware. I have done the lift switch calibration, a full factory reset, and the XY offset print actually prints fine - the extruders are raised and lowered appropriately and there is no major offset noted. Thanks for any help that anyone can offer.
×
×
  • Create New...