[Unknown build plate, newest firmware and newest cura on ultimaker s5 pro bundle]

I upgraded to 5.2 cura and all the file sliced, when plugged into print unknown build plate type. Is there an option to pick what kind of build plate your are using and if there is where is it?

I cant seem to find it.

 

Thanks

[Air handling unit not found during print]

I have this issue on at least 2 of my printers, both S5 pro bundles.

 

it will be printing fine, then all of a sudden with no one near the machine it get the air handling unit not found error and has to be reset which in turns ruins my print.

 

I then restart and its fine again with out touching anything.

 

Why does this happen and we make it not a fatal error in the firmware?

 

 

thanks,

kevin

[Infinite Material Solutions: Aquasys]

I'm having them same issue with aquasys in s5 pro bundle with robot on the side. it breaks in the bowden tube after the feeder.

[Aquasys 120 wont extrude or even load.]

I figured it out and its pretty terrible reason.

 

I had my other printer printing at the same time then i noticed it was doing the same thing with other support material.

 

It was cura 4.9...

 

I sliced again in 4.8 and it was flawless.

[Aquasys 120 wont extrude or even load.]

I wanted to try aquasys 120 with nylon but I cant even get it to load half the time just gives me a E54. 

 

When I do get it to load it doesn't extrude for the first few layers then starts...

 

What do I need to do to get this filament to work?

 

Thanks,

Kevin

[ER65 With TPU]

You were correct I let alot of tension out of the feeder gear and have had no problems since.

 

Thanks so much

[ER65 With TPU]

Im getting a issue when printing with ultimaker tpu where i get er65 error messages. Do the feeder gears need to be tighter then the middle line?

[3DXTECG Carbon Fiber PA12]

Every time a print finishes it gets stuck in the hot end and I have to do the stuck procedure. How can I stop this?

[UM S5 WiFi Setup stuck]

I am also having the same problem on UM5.

[Blue CPE Wont stick to PVA]

Im having trouble getting blue CPE to stick on top of PVA its jut curls at the corners and comes up. I have tried slowing it down, which hasn't help at all. Im also using .8 nozzle im not sure if that make a difference. Any thoughtS?