Jump to content

Dublin1

Dormant
  • Posts

    2
  • Joined

  • Last visited

Personal Information

  • 3D printer
    Other 3D printer

Dublin1's Achievements

0

Reputation

  1. Thank you! From your information I understand understood how it works and my solution now is to add a .inst.cfg file for my printer for super quality and 0.6 nozzle and then my profiles shows up. However I'm a bit worried that the file I added will be removed in future upgrades - anything you know about? To me, the correct solution would be to change the quality type "super" in the profile. But when I try to do that in the exported file I only get error messages while trying to import the changed file. Is there any way to change quality type in a existing profile?
  2. Hi, I changed nozzle size from 0.4 to 0.6 and then I cannot access my profiles, I only get the standard profiles that comes with cura. When I tried to import one of my profiles into cure when 0.6 nozzle was selected I get a warning "This profile is not visible because quality type "super" is not available for this configuration.". So to this I have two questions - how is quality type of a profile determined? The profile in question has no settings that should be in conflict with having a 0.6 nozzle. - If I would like to start reconfiguring an old profile for use with a different nozzle size - how should I proceed when I cant open it into Cure when the other nozzle size is selected?
×
×
  • Create New...