shayan

Heated bed was off and magigoo glue was used....actually you can notice that after certain distance the layer evens out. Thank you

Nope acceleration is 500 and jerk is 5😭

I have been experiencing micro layer shifts if i am not wrong in 3d print parts. they generally appear when there are features like circular, square holes in model and evens out after certain distance. i am not able to figure out whats the issue. all the belts, pulleys and screws are sufficiently tight enough. no slip any where. cura engine also dosent shown any shift in layers while simulating layer view. someone please hep me. i am fed up of these micro layer shifts.

i have been experiencing micro layer shifts if i am not wrong in 3d print parts. they generally appear when there are features like circular, square holes in model and evens out after certain distance. i am not able to figure out whats the issue. all the belts, pulleys and screws are sufficiently tight enough. no slip any where. cura engine also dosent shown any shift in layers while simulating layer view. someone please hep me. i am fed up of these micro layer shifts.

did you figure out the solution for this....if so please let me know. i am also facing the same issues and not bale to rectify at all. its taking my nerves down. all belts pulleys and screws are tight. please some help would be appreciated.