philipp6400

Hello, We´re using some Ultimaker S5 Pro Bundles in our factory for printing Prototypes out of PA6 GF30. Unfortunately, there are always problems with the Material Station. As soon as an error (ER59, ER58, ER57, ER61, ER70) with the Material Station pops up during printing, it is not possible to continue printing. Thus, we often had to throw away almost finished prints, which often took days. And this only because the firmware is not able to resume the print by a wizard at the same place after correction. Ultimately, the problems were mostly related to third-party material Owenscorning X-Strand PA6 GF30, which is qualified for the Material Station. Problem with this material: the end of the filament is taped to the spool with a piece of armor tape, but this causes the tape to come off with the end of the filament and jam in the inlet of the Bay at the Material Station. Then, logically, the material station can no longer feed the filament and sends Error59. No matter how... even if this is a fault of the material supplier - it should still be possible to continue printing after this - especially with this expensive material.