UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I have a question about padding the thing you are going to print. if I have a cube of 10mm by 10mm. and I make it 100% full then it takes about 12 minutes. but if I do the same cube but then 5% it will take just as long. but when I print it it just stays 100%