Mine2209

Updated to 4.6, sliced my print with ironing on and after an ironing layer the flow is not returned to the usual print rate to carry on so the print fails as it doesn’t extrude enough. I have re sliced and restarted but 3 failed prints now and the exact same point. If I manually go into settings on my printer it shows 10% flow and if I increase it back to 100 then the filament does start flowing again but obviously too late. is this an issue known or can you think why this is happening?? How does the change back to normal flow get represented in the Gcode ? and then I can check if it is returned to normal as I can’t find any m221s in there.