Jump to content

kingend

Member
  • Posts

    3
  • Joined

  • Last visited

Personal Information

  • 3D printer
    Other 3D printer

kingend's Achievements

0

Reputation

  1. Thanks for the reply. Good thinking - But I tried changing the 'stair step settings' and that did not make any difference I am out of ideas at this point. I will have to place a support blocker so that the weak supports that failed are not printed. I did not want to resort to such workarounds because I dont know which support would fail where when I print a model for the first time. I wanted a reliable printing experience.
  2. I posted here because this seemed like the best forum for cura questions any thoughts anyone? feedback is greatly appreciated
  3. This is causing supports to break mid-print and spagetti. I am using cura 4.5 Note in the below screenshot that 'Support Z distance' is set to 0.12 which is equal to the 'layer height' setting I expected supports to start printing with a '1 layer gap' on the model but supports started printing after a 3 layer gap. Can anyone help?
×
×
  • Create New...