Jump to content
Ultimaker Community of 3D Printing Experts

MadVit

New member
  • Posts

    1
  • Joined

  • Last visited

MadVit's Achievements

0

Reputation

  1. Printing a model which is big for my device if laying down, but fits when tilted. It will fall without support, so I've dicided to add a custom supports at the center of a mass. Added some. While printing I saw a gap between my support and a model. Fixed this with some paper. Next model - curra've added hole supports. I've added mine. My - with gaps, cura's OK. Examined sliced - yep there is a gap. So the question is how to use custom supports correctly.
×
×
  • Create New...