I'm not sure if my print problem is related to my Cura settings or something related to my bed/printer itself (nozzle/bed distance, etc.).
This is a soap dish I created in openscad. When I print the first layer it looks great. But the second and third layers show some PLA lines that look like a 'bubble' effect. I don't know what is causing this.
I tried two different filaments, gray and yellow with the same results. The gray photo shows the first layer, which prints almost perfectly. The yellow photo shows the second layer and the start of the third layer. These layers don't lay down smoothly like the first layer.
Does anyone have any ideas of what I can adjust/change to eliminate this 'bubble' effect?
Thank you...