Hi all.
Having an issue with CURA. I am testing a print of a monitor standoff I designed. I designed it with 1,2mm wall thickness so I can print 3x,04mm walls and obtain the 1,2mm desired result. Trouble is, cura is printing the middle line in a discontinuous fashion, causing severe issues with adhesion, PLA buildup on the extruder hot end, considerably longer print times, etc... This happens in layers where it's just the wall being printed. If I check top layers, as soon as it starts working on those, it's all good.
This is layer 1 (of the test print as part is shifted down) and you can see the interrupted line in that bottom arc, though the top arc is ok.
All the way up to layer 13, last layer of just walls.
Then, starting at layer 13 till 16, when the top layers start, it prints the 3 walls just fine.
Attached, the 3mf file in case it helps.
Does anyone have any clue as to how I can solve this?
CFFFP_20200527_BACK STANDOFF.3mf