Jump to content
Ultimaker Community of 3D Printing Experts

Ian_Tranter

Member
  • Content Count

    3
  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. @Torgeir No I haven't, I'm just running through the two help files above, will check that also,. Regards Ian
  2. That's awful, we can't print a good part no matter what... Do you know if there is a contact number as I think there is a compatibility issue with the software? If admin see this post please advice?
  3. Hey There Friend. Have you seen a solution to your issue, I'm experiencing the same issues and have done almost everything you have apart from checking the firmware. I also print with a brim and have only seen this happen on software version 4.2.1., see images attached Please advise of any solution you may have? Does anyone know of a phone line for support?
×
×
  • Create New...