Jump to content

raslocum

New member
  • Posts

    1
  • Joined

  • Last visited

Personal Information

  • 3D printer
    Other 3D printer

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

raslocum's Achievements

0

Reputation

  1. I am attempting to print a single wall body using Ultimaker Cura 4.6 on a Creality 10s pro in PLA. using surface mode. The prints are otherwise beautiful in my newbie opinion, but..... I tend to get blobs where the layer ends. and worse I often get holes like in the picture where a new layer starts. I have turned coasting on and off with little effect. I have experimented with different retraction settings. Nothing seems to change this. I have slowed print speed to as low as 25 mm/s. Nothing seems to help. Any advice appreciated.
×
×
  • Create New...