Blaast

Member

Personal Information

The recent visitors block is disabled and is not being shown to other users.

Ultimaker Cura 4.6.1

Blaast replied to Blaast's topic in UltiMaker Cura

Oooh. Okay, good to know ! ^^ So if I set line with at .15 for my .2 nozzle and .8 for my 1mm even though the printer is set up for .4mm nozzle it should work ? Thank you very much !
- June 21, 2020
- 4 replies
- - 1
- - CURA
  - HELP
Ultimaker Cura 4.6.1

Blaast posted a topic in UltiMaker Cura

Hi, I'm trying to slice an object on my 0.2mm nozzle for a custom 3D printer (Artillery Genius). 0.4mm nozzle and 1mm nozzle work fine but everytime I try to set up 0.2mm (or 0.25 or 0.3mm) it resets it back to 0.4mm after any change. If I try to slice it, It gets back to 0.4mm and slices at 0.4mm. Anyone has the same issue ? I'm switching to slic3r for testing purposes but I do like very much Cura Uu Thank you very much! Best regards, Thomas D
- June 21, 2020
- 4 replies
- - CURA
  - HELP
Impression avec buse 0.2mm

Blaast replied to Mosolee's topic in Français

Bonjour, perso j'ai un autre problème, c'est que Cura refuse d'enregistrer ma buze de 0.2mm Aucun problème avec 0.4 et 1mm cependant donc je suis un peu confus. Peut-être que ton problème est similaire cependant ?