Jump to content

Balbers01

Member
  • Posts

    4
  • Joined

  • Last visited

Personal Information

  • 3D printer
    Other 3D printer

Balbers01's Achievements

0

Reputation

  1. Thanks, just installed it and did a test run, doesn't export the temp calls. going to run a test print this week.
  2. I appreciate the help, when will the fix be implemented in your build? Thanks!
  3. Attached. CFFFP_gearstem_c.3mf CFFFP_gearstem_c.gcode
  4. I have a 3 in 1 out extruder with a single heater and in cura I have shared heater checked. My issue is that every tool change there is a M109 to set the temperature which triggers the warmup delay (all filaments are the same temp) and yields significantly longer print times. Is there any way to eliminate these temp calls on tool change and just let it stick with the initial temp? I've watched during the change and the temp stays steady at 200 degrees even before the call is made.
×
×
  • Create New...