Hi,
Just wondering if anyone can help me. For a year now I have successfully printed thin walls for my cutters using the Prusa slicer with my Anycubic i3 Mega.
I recently purchased an Ultimaker S5 and have not been able to produce, clean, strong, thin walls for my cutters (as in picture) since. I'm sure the S5 can do it but so far I have had no success.
Can anyone help me with this or help me to configure Prusa to use with the S5. I have seen on many forums that Cura is not good for thin walls.
I typically need the cutting wall between .46mm and .49mm in width. I use plain PLA.
Thanks in anticipation for your help.
Desperate,
Stephen.