Hello,
My UM2+ is having issues which seemed to be pointing towards under-extrusion. As such, after working with UM support and consulting countless posts on this forum, I ran through the normal troubleshooting, cleaning and lubing procedures and replaced parts (see below), I regret to say that the problem persists. My layers are uneven and my edges are not straight (see below). I rely on this machine and it's been down for almost 2 weeks. I would greatly appreciate help from you experts out there.
Replaced parts:
bowden tube and collets
nozzle sensor
tfm coupler
hot-end isolator
heater block
new nozzle
Thank you,
Sam