me0815

Hello, It still didn` t work with Cura... I then tried it with Xloader and it worked perfect:) now, alfter the FW upload its also "detected" by Cura. So a big Thank you:) best regards, Simon

it worked right now but(of course) there is a Problem about the hex file... does someone have a link wehere I can download Xloader?

Thanks a lot, I actually haven` t thought about the IDE yet. Will try it soon.

Yes, I did so but Pronterface still just shows rubbish.

Hello, I could fix my problem by resetting the printer. Thanks a lot! but right now the printer works and connects with my Laptop but cura doesnt recodnize it... When I connect it with Pronterface It shows something like "incorrect baudrate" (i also tried it with some baud` s) Sooooooo.... do you have any suggestion? best regards, Simon

well, so far so good. It works now, thanks a lot. Right now it doesnt connect to cura and when I want so connect it to pronterface it connects but always shows "invalid baudrate" (I already tried with difrent ones). Do you have any suggestions?

I had to do a reset, so I need to load the FW now. Yes, my operating System shows it.

Hello, i just fixed a problem i had with my Ultimaker 2 and now, when I wanted to update the FW it always shows something like: "device not migrated" so I found out that it has something to do with the drivers and so I searched for drivers to download- but found nothing. So I wanted to ask you if someone knows where I can get the rivers from:) Best regards, Simon (I know that coura should automatically install the drivers, but hat doesnt work somehow. also tried it with some later versions of cura)

I also checked the the power cable and measured, everything allright.

I already checked: on both computers are the latest drivers.

so that is the problem... no ba-dum sound and no device is recodnized.

Hello, While I was updating my UM2 FW suddenly my Laptop crashed 😞 When I then wanted to update the FW again, I noticed that the ultimaker doesnt work, the display shows noting, the board is blinking and the LEDs ar lighting a little... and the worst: I cannot connet it with my Laptop (also tried it with my PC and with diffrent cables and with pronterface) So do you have any suggestions??? (a reset knob on the board is misssing xD ) Best regards, Tom

Carla_Birch Thanks a lot, I contactet hin:)

Hello, While I was updating my UM2 FW suddenly my Laptop crashed 😞 When I then wanted to update the FW again, I noticed that the ultimaker doesnt work, the display shows noting, the board is bliking and the LEDs ar lighting a little... and the worst: I cannot connet it with my Laptop(also tried it with my PC and with diffrent cables) So do you have any suggestions??? (a reset knob on the board is misssing xD ) Best regards, Tom