dadinfinitum

Thanks for the insight. I've also been told to check my fan settings. Here's hoping it works.

I have a Creality CR-10 Mini, and I've had a constant problem of filament clogging in the Bowden tube. I've gotten through entire spools with no problem, but then sometimes it'll print for an hour when a clog occurs. The stepper gear will start slipping since it can't push any filament in, and if I try to manually push/pull the filament, it goes nowhere. I've ran filament at various temperatures, I've used different brands of filament, I've used different Bowden tubes. I check the level of the bed before each print, and when I connect the Bowden tube, I keep the nozzle unscrewed about 1-2 turns, push it as far as I can, and then screw in the nozzle. I'm also very careful to square the tubing before putting it in. I've cleaned the stepper gear with a toothbrush and alcohol, too. I don't know what the cause is, and I don't know what to do. I'm running on fumes trying to figure it out, and any help would be appreciated.