Hi
After working for long times with Cura 4, I decided to try freshly released v5.0 and I have noticed quality degradation on one of my objects. It's actually a small vase which has thin fins, like you can see on images. In 4.13.1 it look fine, while in 5 I can see lot of retractions on the fins which will cause most likely lot of ziting in the final print (did not print it yet from v5). Even print time went from 11 hours to 13 hours, while retraction time (in percentage) went from 16% to almost 45%. I believe it's connected with variable line with as I can observe that first 1/5th of the fin is drawn as single line and then is converted into two lines, while in 4.x it was build from two lines, in one continues motion.
I'm using same 3mf in both versions with same settings - any idea how to overcome this in v5?
BR
Ivan
Lamp shade v01.3mf