George2020

Hi! When trying to print multiple meshes at the same time, it is not possible to select "Sharpest Corner" Z-Seam Alignment for some of them. How to reproduce: (Cura 4.7.1) add at least two meshes set Z Seam Aligment to User Specified select one of the meshes, go to per-object settings (normal mesh) and set Z Seam Alignment to Sharpest Corner for this mesh slice you will find that "z seam alignment" is "User Specified" for all meshes

I was wondering if there was a way to leave a (for example square) hole in the bottom of your print, so you can pour in plaster afterwards to make the object heavier (using gyroid infill so it can go everywhere) Tried to do this with a cube with "modify settings for overlap" and setting it to 0 bottoms.. but the object still ends up "closed" but with a cube shaped cutout.. is there a simple way to do this? You can always adapt your model to have a hole and an "inside" of course, but thats a lot of bother when all you need is gyroid infill + and a hole. So.. dremel it?