jill_henderson

@Framar it is an Ultimaker 3

Hello! Does anyone know where to get a good quality but relatively cheap 0.4 mm nozzle? I ordered some from amazon but they are too short and are not the best even though it had good reviews!

@gr5 1) yes its PLA 3) yes its the ultimaker 3 4) yeah i read that PVA doesnt stick to other materials very well so i made the brim made from PVA 6) It does need support, it is not far enough into the prin to show, but the places that are forming support will be support some "hovering" PLA I will try to cleaning the bed and removing the brim thank you!

Hello Ultimaker community, I am relatively new to 3D printing and I am having trouble solving this problem! Below is an image of an assistive device I am trying to print but i am having trouble trying to print the support material! Within the blue circle there is supposed to be a layer of support material but for some reason it will not stick to the initial layer, and in red on the upper half of the green boarder the support material is very blobbled and not working well where on the lower half its working great! MY original print worked well then i made some edits and tried to reprint it i started having these problems. I have already tried drying out the PVA support material, and i am unsure if it is the nozzle bc some parts are printing cleanly?

Hello! I am relatively new to the 3D printing industry and am having trouble with my Ultimaker 3 2nd nozzle. I am almost certain it is clogged as no filament that comes out of it. I tried to do a hot and cold pull, as well as poking a needle in the end to try and break up any hardened filament and both do not appear to be working. Does anyone know how to unclog the nozzle?? i also read online that you can remove it, however most cites also say that you need to have the print nozzle clean before you can remove it so I am confused and stuck!