Trickster

ty. i got some new keene valley plastics pla and was going to print a temp tower to see what temp works best for that pla. had to print holders first to hold the 5# rolls i did not know it stayed until thank you i deleted it

I upgraded to the latest version of cura. my stl's were slicing fine before upgrade. now when i slice (PLA) it is adding at layer 5 a custom layer and bumping my temp up to 220 adding an m17 600/600. depending on how large the print is it also adds an m104 s 215 ans m104 s210. i started the print at 190 or 200. i do not know where or how i am getting these custom layers. is this normal or did i mess something up? thank you in advance