Jump to content

ayram45

Dormant
  • Posts

    5
  • Joined

  • Last visited

Everything posted by ayram45

  1. @amedee merci de ta réponse, et donc les carte blanche sont des ultimaker original plus ?
  2. bonjour, récemment j'ai fait une mise à jour de mon umo à l'aide se cura ultimaker . Une fois la maj finie je tourne la molette de l'imprimante et l’écran change l'affichage et écrit des lettres par-dessus l'ancien affichage en voyant ça je l’éteins et en la rallumant écran blanc rien d'afficher donc bon je check avec cura et là rien ne répond même si elle est détectée. Je retente une maj toujours rien. Je vois pas comment régler le problème. j'ai déjà essayé d'installer Marlin avec Arduino mais ça fait pareil. j'ai essayé avec un autre ordi, essayer différents firmwares mais rien ne marche
  3. how to factory reset the firmware of the ultimaker original ?
  4. and i cannot print 😕, my stepper doesn't move. i think it's the software that has not installed a 100%
  5. hello, i tried to do a firmware update, i did the update with cura ultimaker. Once my update is done I turn off my 3d printer and I close the program when I turn it on again, the display was empty as in the photo. I don't know how to display the menu again (the printer is still detected by my PC, and I tried to reinstall the firmware but nothing helped)
×
×
  • Create New...