Jump to content
Ultimaker Community of 3D Printing Experts

ScottStadick

Member
  • Content Count

    2
  • Joined

  • Last visited

Community Reputation

0 Neutral
  1. Ah ok, thank you for the recommendation. Y clicks but doesn't register. X is fine. I'll read up more with that information.
  2. Recently purchased a refurbished ultimaker 3 (first 3d printer) and went to welcome setup. The first thing it did was bash into the back left corner. So I looked it up, performed the steps and found out it's the y limit switch. It makes the click but doesn't register. There doesn't seem to be any further information on how to resolve this on any of the other forum posts, and this website only redirects you to the troubleshooting page (with no solution in there) or the forums... anyone know how to actually get help with this?
×
×
  • Create New...