[How do I turn off this initial triangle?]

On 8/27/2020 at 9:22 PM, theTicFramedtheadverb said:

Cods69, thanks again.  SO, just to clarify

IF I go into my Creality Cr10Spro, and turn OFF AUTO-Leveling,

but STILL use the G29 code,

Creality will READ the PREVIOUSLY STORED values every time it prints

 

and then I can just go in and TURN ON AUTO-Leveling about every 10 prints, it will RE-DO those stored values?

thanks

 

Short answer:  I don't know.

I've only had my CR10s ProV2 for less than a few weeks and it's my first 3D Printer.

If I work this out (as there is some additional weirdness I'm getting with leveling and Octoprint/Pi) I'll post back here.

Lots for me to learn...

 

[Cura 4.7 crashes when opening STL file]

Thanks all - this fix worked for me: https://github.com/Ultimaker/Cura/issues/8235#issuecomment-682036305

Easy enough to do and it works for me on Win and worked for a mate on Apple (there is no python35.zip on Mac, but the FastConfigParser.py(c) is in the install directory somewhere.)

[Cura 4.7 crashes when opening STL file]

Problems here as well, on a 4.7 clean install, worked ok for a few prints, then started crashing importing any stl I have, after changing a few small profile material settings and the theme.

Using NVidia drivers here, on x86 Win.

4.6.2 is fine and never had such an issue.

[How do I turn off this initial triangle?]

12 hours ago, theTicFramedtheadverb said:

WOW ! Deceptive is not the word for it !

you hve to actually START to scroll before a scroll bar appears !  but i did find it !  Thanks very much !

You're welcome.

Of note, I just did a fresh (well, the installer told me it was fresh removing config) install, where the new 4.7.0 Cura seems to have the M420 removed/replaced by default for the CR10S Pro.

Thanks Ultimaker devs.  I do appreciate you listening and supporting other hardware.

[How do I turn off this initial triangle?]

8 hours ago, theTicFramedtheadverb said:

thanks for reply, but that does not work;  the original slicing/calibaration code is not in the printer sdction of "start printer" that i can find. 

Did you scroll down?  Move your mouse to the right side (of the "Start G-Code" box), left mouse click,  and a scroll bar appears.

I know, it's a bit deceptive, but it's there.

 

You can also expand the "Machine Settings" window and there it all is. 

[How do I turn off this initial triangle?]

55 minutes ago, theTicFramedtheadverb said:

is there a way in CURA to put this in as a permanent change or add-on, to remove the other lines?

Preferences/Configure Cura/Printers/Machine Settings/Start G-Code

[How do I turn off this initial triangle?]

Signed up specifically to say thanks for this thread.  That triangle on my new CR10S Pro V2 was driving me mad!

Much appreciated, to all those who worked this out.