Grenex

It was causing issues where I would level the bed and then the auto level was reading differently when the printer did it before each print See above comment on how I disabled it

This worked PERFECTLY! Thank you so much for the help!!!!

But how do I stop this all together from bring in the gcode? I don't want it at all... No matter what the proper code is

This is a great guide! Thank you so much!

I installed the 4.7 update last week and now my Creality CR10S Pro does an auto bed level now at the start of each print. How do I disable that? note that in my attached images, my Gcode shows that G29 auto level command, but my machine settings do not have that setup. This action never occurred prior to 4.7 and I have poured over the settings unable to find where this new line in the GCODE is being set.

I installed the update, but on my Creality CR10S Pro it does an auto bed level now at the start of each print. How do I disable that? note that in my attached images, my Gcode shows that G29 auto level command, but my machine settings do not have that setup.

I installed the update, but on my Creality CR10S Pro it does an auto bed level now at the start of each print. How do I disable that?