Hello,
I am facing a new issue with my good and old Ultimaker 3.
When I send a new print, active leveling starts as usual. It tests Printcore 2, shifts to 1, test again and, when shifting to Princore 2 again, it hits the white piece in the right wall in a wrong position and fails to move Princore 2 nozzle down, leveling it again touching printcore 1 nozzle in the bed.
The interesting fact is that if I go to settings -> Build plate -> Active leveling, it runs the leveling correctly. But, if I send a new print, I face the above mentioned issue. Right now I set the active leveling to run once a week to be able to print. However, I would like to fix it to be able to level before every print.
Thank you in advance,
Victor Sardenberg