Hello, made an account so I could ask this question not sure where else to turn.
Very new to 3D printing, just got a brand new Labists ET4 printer and was excited to start printing projects. First of all, I printed the preloaded projects that came with the sd card and it printed perfectly.
I searched online and found that Cura is the best software to use when slicing. I searched on what Printer to set it up as (since labists ET4 is not an option when selecting a printer) and it said that the Anet ET4 works well with it. When I slice my project it looks great on Cura but when I print the project, from the first lines (using brim as a base) it starts off centered and then starts to drift off to the left every single time. If anyone uses the latest version of Cura for the same printer can you please share your settings so I can compare? Or if you have any suggestions on the settings for the print I would greatly appreciate it.
I use PLA filament, 1.75 mm
I run my nozzle heat at 200 degrees
and my bed temp at 75 degrees.
my bed is level and like I said, it printed the preloaded items just fine before I had this problem. I try to mess with settings but at the same time I don’t know what I am doing with it and am wasting filament at this point.