MikeZamalis

Hi Chris, Thanks for offering to have a look. Attached to this post is a zip of the key log files form my machine. I'm interested to hear what you see in them. Thank, Mike Mike Log Files.zip

Hi guys. I was running along fine with my S5 connected to digital factory. Perhaps a week ago I was not able to see the printer on DF. Today went to the printer display and disconnected from DF and went thru the re-connection process. I am still not able to see it on DF. I can see it fine through the Monitor screen on Cura Any guidance?

Ulrich, thanks for the reply. My use case is a little different right now. I wanted to retract the filament in order to disassemble and move my system to a different table. I will let it set to see if it decides to play along. -MHZ

Hey Everyone, I have 2 spools in the material station. My print is finished and I can see that both materials are retracted up into the bowden tubes approximately 2 inches above the cores. I want to remove these two spools. The eject button lights are blue. The eject button gives no response when I push it. I checked the material menu and all buttons are grayed out. For each material it says it is in use. I have rebooted and have the same situation. What am I missing? I'm sure its something simple. Thank you in advance, Mike