UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
I also had this problem after updating to 4.7.1. Previously sliced prints turn out fine.
To add to the confusion I had just made changes to the hot end at the same time!
Will give 4.6.1 a try and see what happens