ardynamics

Thank you, seems like my spring twisted/rotated itself out somehow. Will try turning it back up, if that doesn't work see if I can get it repaired, still under warranty

Hi, would someone be able to make a clear photo of how the spring is supposed to look? I pulled out a BB0.4 to replace it with an AA0.4 , but I couldn't insert the printhead. And then I noticed the spring in there. Not sure if this is something I can (or should) fix myself...

I will test it again this weekend and try to file a ticket with the logs and everything. But to be clear: not that big of a deal to, I just remember to 'unload' whenever I have to abort a print (hopefully that happens not too often 😛 ) I am mostly using 3rd party filaments, except for PVA. Indeed, the printhead was 'purging' before printing. I could hear it trying to purge material in a few short sessions. But as the filament was parked, it did not far enough into the printcore We mostly print small parts indeed

Hi, thanks for the response. I indeed started a new print and it wouldn't extrude, because it did not 'unpark' the filament. I always have the brim enabled, and it didn't extrude the entire length of the brim and even 15 seconds into the print, when I manually aborted again. I did notice the filament was parked higher in printhead 1 then printhead 2.

Thank you for the fix, big help to 'unstuck' the machine. Unfortunately there seems to be one more issue with the 'parked' filament: 1) Start a print 2) abort the print 3) confirm removal 4) hit 'no' for retry => filament gets 'parked' above the printhead, see photo => Printer thinks the filament is still present in the printhead, see photo => Next print will fail, because it will print without filament Manual resolution: unload the filament(s) using the unload button.

We are having the same issue, unable to unload material. We've reverted back to the previous firmware. I do want to stress that we are really grateful for this new feature, as we are often repeating prints of short duration, with the same filament. It will cut back on time a lot. Can't wait for versions 5.8.1 🙂