arkelec

After a lot of wasted time, the solution was to reset the printer from the onboard menu.

It connects, then after sending a print, drops off. I can make it connect again, but it just repeats dropping off etc etc. I had a look at the machine log. What does this mean: Log data: Oct 09 09:23:05 ultimakersystem-ccbdd3007e3d PrintClusterServer[3196]: ERR - app.libs.watchdog:103 - Thread '<Thread(StartUp, stopped daemon 2693768288)>' failed to tick the watchdog! Alive: False I did a search but could find nothing. There are a load of other entries in the log, Log data:

Printed the same items from Cura another 4 times, no repeat of the issue.

Just had this error, with only one material loaded. I just pressed resume, after checking the feed. Another 90 minutes to go to completion. Firmware was updated to 5.8.0 around 9th September & I'm sure I printed this file after that date without issue.