Hi all,
For the last week or so we've been trying to resolve an issue affecting all prints on two of our UM3's wth PLA. The prints end up very weak & under extruded, when inspecting the filament it is ground down in multiple places.
The only setting i've changed that resolves the issue it turning retractions off. Whilst this does produce the required print, it is very stringy I guess due to dribble from the filament not being partially retracted.
I have tried changing retraction settings to improve the print, but with no success. Images below show default retraction settings (Max retraction count = 25) and what I had changed to (Max retract count = 4) prior to turning retraction off entirely. Also included are images of the filament, failed print and a completed print with retraction off.
Cura SW has last updated January, printer Firmware was done at the same time.
Any advise on how we can resolve this whilst keeping retractions would be massively appreciated.
If I have missed any crucial info, please let me know. Thanks!