UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
tnx,
i tried the 3mf file, but the behavior is the same.
"Outer Wall Inset" and "Horizontal Expansion" and "Horizontal Hole Expansion"
are all set to 0.0
All settings are basically defaults.
i just noticed when i change from draft (0.3mm) to normal(0.2mm)
it works. seems a bit strange to me.
hi,
cura jumps from the 2 conical tips to the front of the can
instead of following the wall.
which setting might cause this?
https://www.thingiverse.com/thing:4609601
CHEERS